Two-way playlist sync
A normal sync goes one way: the source is the master and the target follows it. A two-way sync keeps two playlists the same whichever side you change: a song added on Spotify reaches YouTube Music, and a song added on YouTube Music reaches Spotify.
Set it up
- Make a sync between two existing playlists of yours (a two-way sync needs to write on both sides, so not a public link or someone else’s playlist).
- In the editor, turn on Two-way. Trackhop adds the reverse sync, shown as a card marked ↔.
- Pick the schedule as usual: both halves share it, with the same rules, colour, label, tags and star. Editing the ↔ card opens the original sync, and deleting or turning off either acts on both.
Removals too
By itself, two-way only adds: a song you delete on one side comes back from the other on the next run. Turn on Removals too and a song you remove on one side is removed on the other as well.
- It starts after the next run, which notes the songs both sides have. Only songs that were on both sides and then disappeared from one count as removed.
- A song the service hides or no longer plays is not treated as removed.
- When a run would remove a lot at once, the removals are held back, as with mirror removals: the card says so, and you confirm them in the preview with Remove these tracks. Scheduled runs keep holding them back.
Where it works
In the app, on Trackhop Desktop and on a Docker server (the web page, the
API with twoWay and twoWayRemovals, and the command line with --two-way).
A two-way pair stays where it was made: handing a sync over to your server
leaves two-way pairs out.
See also Keep playlists in sync · All guide pages